Oct 2, 2001 · The green-orange wire is your +12V illumination source, it's the correct wire to use for the boost gauge illumination. 1994 Supra Turbo 1A1 6SPD Save Share

Apr 1, 2010 · Right i got some greddy gauges (oil press, water temp, boost, ext. temp) and im wondering how to wire them up? There are 12 wires out of each gauge and...

Nov 26, 2015 · Gauge is electrical and the sending unit has red, white, and black. The sheet lists the red and white on the gauge as 12v accessory power, black as ground (obvious) orange as 12v switched (planning on headlight switch). And the green it …

Red Constant power, 12v. This can be found on the red wire of your turbo timer. Otherwise use a test light and probe for power with the ignition off. Orange Switched power, on with ignition. On your turbo timer use either the green or blue wire at your turbo timer. The cigarette lighter is also a good place to get switched power. Use the black

Oct 15, 2004 · It doesn't match the bmw orange 100%. I'd say 85%. Its slightly more red than orange but it still flows nicely with the interior. It dims along with the rest of the lights too. The 60mm gauge is huge! Much bigger than I thought. When i turn the key (car not on), the gauge moves from the very bottom to "zero".

A: This gauge uses a specific wiring harness and more than likely you have inadvertently swapped harnesses with another gauge. The wiring harness color order for the electric boost gauge is: white, orange, red, black & green

The AEM Boost Gauge has 7 different backlight colors available to the end user, which closely match some of the more common factory dash panels: white, blue, green, red, orange, light blue, and aqua. To change the backlight color, rotate the backlighting switch using a small precision style screwdriver. The backlight switch is accessed

Dec 28, 2021 · I have these gauges, the red should go to a 12v source that always has power, key on or not. The white wire is the one that gets switched 12v, so this one gets power only when the key is on. The orange wire will set what color the gauge is (it's called amber in the color chart on those instructions).

OPTIONAL: Daisy Chain Your Gauges – If multiple EV2 gauges are being installed in one location (such as a pod), you may use a single set of the Ignition, Ground, and Dimmer wires to connect all of the gauges. Simply pass the wires from one orange connector to the next one in a “daisy chain” configuration. A single 1-amp fuse will protect ...

Nov 29, 2024 · The orange wire should connect to either a green or blue wire on your turbo timer harness. You can tee into the ignition column and that wire will be blue or you can attach switched power to...