2018年10月25日 · roofing nails, minimum 12-gage [0.105 inch (3 mm)] shank with a minimum 3/8-inch-diameter (9.5 mm) head, complying with ASTM F1667, of a length to penetrate through the roofing materials and not less than 3/4 inch (19.1 mm) into the roof sheathing. Where the roof sheathing is less than 3/4 inch (19.1 mm) thick, the fasteners shall

2021年8月27日 · 2018 IRC R905.2.5 Fasteners Fasteners for asphalt shingles shall be galvanized steel, stainless steel, aluminum or copper roofing nails, minimum 12-gage [0.105 inch] shank with a minimum 3/8-inch-diameter head, complying with ASTM F1667, of a length to penetrate through the roofing materials and not less than 3/4 inch into the roof sheathing.

2009年10月19日 · structural panels. Figure R602.10.6.2 seems to indicate the use of nails, however, Table R602.3(1) allows the use of staples [ Note b ] in fastening the wood structural panels to the studs. I am looking to get some clarity on what is "actually" required to attach these osb panels to the studs in a compliant manner.

2022年7月22日 · Thanks for the info. We had planned on this being a longterm home so we went through the correct procedures as far as number of nails per shingle, tar on the drip edge, correctly sealing the valleys with top quality tar rolls instead of metal, etc. We've also replaced the main exterior circuit panel, post disconnect, then inspected as well.

2009年10月16日 · Some will call with every question they may have. I have respect for those that call and those that remember what was called out on their last job. It is when the same violation occurs on every job the contractor does, it shouldn't be to difficult to remember that roofing nails are not hanger nails.

2020年8月2日 · Maybe you have been doing it wrong for years. “2015 IBC 1507.2.6 Fasteners. ... a length to penetrate the roofing materials and a minimum of 3/4” into the roof sheathing. Where the sheathing is less than 3/4”, the nails shall penetrate through the sheathing.“

2011年6月23日 · The code used to mention staples and now they are gone and it's nails only. I work with an inspector that thinks it is too onerous to write that correction. The obvious implication is that the roof must be striped and redone. The retort that "It's code" falls flat without a reason why. I can think of several reasons that fail to impress.

2009年10月16日 · If moderate or high wind conditions are likely, additional nailing in the field of the sheet may be necessary. Staples should not be used in place of nails. ®22® As an alternative to using nails, apply Perm-A-Barrier WB Primer to the roof deck at a coverage rate of 250–350 /gal (6–8 m /L). Perm-A-Barrier WB

2010年6月22日 · The AHJ (You) are the one who "approves" the connector. This could be nails if they will meet your uplift requirements.Clips and straps are not the only option check out Simpsons SDWC. 400 to 600 pund uplift depending on the wood species. They work great, contractors doing exposed wood projects really like them.

2019年6月22日 · Inevitably nails land in the gaps and either don't hold a thing and/or just blow right through. Callbacks suck and finding roof leaks suck too. It was common practice to have a clause in the contract that once the roof was stripped down, depending on what was found, plank roofs that were not already covered with plywood would then need to be ...