Murata begins mass production of the world's first 0805-inch size MLCC to offer a capacitance of 10µF with a 50Vdc rating for automotive applications.

You can get 12v, 8v, 100v, or whatever between capacitor leads, depending on the internal resistance of the fan. It’s just a 2 resistor divider. The bulb and the fan resistances.

Everyone knows that the perfect capacitor to decouple the power rails around ICs is a 100 nF ceramic capacitor or equivalent, yet where does this ‘fact’ come from and is it even correct… ...

The new battery pack also boosts the Flux Capacitor's range to about 50 miles (80km), up from the previous 30 mile/48km range of before. Having ridden in the bright orange rocket, those 50 miles ...

Data loss is a concern in telecom, industrial and automotive applications where embedded systems depend on a consistent supply of power. Sudden power interruptions can corrupt data during read and ...

The capacitor is not upside-down, visually/orientation-wise, but in voltage. ... While C19 and C21 are properly taking on +5V and +12V lines from the power supply connector, ...

This time around he’s decided to use a 20,000-volt capacitor, which not only thoroughly rind-blasts these poor, pink seedy fruits (as well as some other fine picnic foods), but also liquifies ...

X7R Capacitors with a 12V Bias . We see a steady improvement as we progress to larger capacitor sizes, until we reach the 1210 size. Going beyond that size yields no improvement. In my case, I had ...

TI’s 12V, 10A, 10MHz series capacitor buck converter achieves over 50 A/cm3 in current density, which is 4X higher than any power solution available.

Therefore switching capacitors independently in all three phases provides only small benefit at an increase cost in terms of sensing, controls, and communications (if there is any). One would have to ...